|
Motor Sports Equipment 
High Lift Pneumatic Jacks
How the Pneumatic Jacks Work
(Click for instructions)
|
| •
Up to 24” of Lift in Seconds |
| •
Up to 1,500 lb. Lift Capacity per Wheel |
•
3 Position Manual Control Valve
|
•
Width Adjustable Lifting Rods
|
• Roller Bearing Lift Slide
|
•
Aluminum & Stainless Steel Construction
|
| Three models are available |
| |
600 lb. – Intended for Indy Car, Champ Car, Formula Mazda, Formula BMW, IMSA Lites, etc. |
| |
1,000 lb. – Intended for LMP1, LMP2, GT1, GT2, Touring, Daytona Prototype, Rolex GT, KONI Challenge, World Challenge, etc. |
| |
1,500 lb. – Intended for NASCAR Nextel Cup, Busch, Craftsman, Truck, ARCA, Hooters Pro Cup, etc. |
| |
Each size is available in 18” or 24” lift height, and operate on 80PSI compressed air or nitrogen. |
The lifts are designed to raise the car at the wheels, either in pairs or a set of four. GT or Nextel Cup cars with short or higher overhangs will typically lift in pairs raising the front then the back. Prototype and open wheel cars with lower or longer overhangs will typically use four lifts raising the entire car at one time.
The lift is not intended to hold the car up for service to the underside and high stands are required.
AMI also has the capability to provide engineering, machining, and fabrication to produce customized parts for the motor sports industry.
|
|
|
 |
